Il sistema completo di raffreddamento a liquido per CPU CORSAIR Hydro Series H150i PRO include un radiatore da 360 mm per un raffreddamento a bassa rumorosità e stile grintoso con una testata della pompa RGB LED. Compatibile con CORSAIR iCUE
sku: CW-9060031-WW
Il sistema completo di raffreddamento a liquido per CPU CORSAIR Hydro Series H150i PRO include un radiatore da 360 mm per un raffreddamento a bassa rumorosità e stile grintoso con una testata della pompa RGB LED.
La testata della pompa RGB LED produce effetti di illuminazione vividi e vibranti da abbinare al tuo sistema.
Tre ventole PWM a levitazione magnetica ML Series da 120 mm a bassa rumorosità forniscono un flusso d'aria migliorato e producono solo 25 dBA di rumorosità alla massima velocità.
Il software CORSAIR iCUE consente di regolare l'illuminazione RGB, la velocità delle singole ventole e la velocità della pompa, offrendo il monitoraggio delle temperature di CPU e refrigerante e altro ancora.
Il profilo di raffreddamento Zero RPM nel software CORSAIR iCUE consente alle ventole di arrestarsi interamente alle basse temperature, eliminando il rumore della ventola.
Opzioni avanzate di controllo della velocità delle pompe per massimizzare le prestazioni o ridurre al minimo il rumore.
La staffa di montaggio è modulare e non richiede utensili, per un'installazione rapida e indolore su gran parte dei principali socket per CPU.
Il software CORSAIR iCUE dà vita al tuo sistema grazie all’illuminazione RGB dinamica sincronizzata, velocità delle ventole personalizzabile per una minore rumorosità e monitoraggio avanzato del sistema.
ULTERIORI INFORMAZIONI
The new Intel® Socket 2011, used on the new X79 motherboards and the new 2nd generation Intel Core Sandy Bridge-E CPUs, has changed significantly from Socket 1366. As you can see below there are no longer the traditional holes through the PCB. There is now a metal bracket that has been tapped to accept M4 screws. Because of this the Corsair
Hydro Series H70, H80 and H100 CPU coolers all come with separate screws to mount on Socket 2011 boards.
Included with the H80 and H100 are four standoffs that have a shorter wider end. These are for socket 2011, the shorter end screws into the metal mounting plate on the motherboard. Install all four of the standoffs as shown below. After installing and tightening down all four standoffs, the CPU cooler is ready to be installed. Next the thumb nuts are installed. Tighten these in an X pattern to ensure the pressure is even, resulting in a good mount on the CPU.
The H70 Core uses the same bracket for socket 1155, 1156, 1366, and 2011. Again socket 2011 uses larger M4 screws and does not need the backplate. Make sure all of the holes on the retention ring are towards the outside (as seen below). Then install the M4 screws through these holes. The retention ring should then be put on the H70 Core. The H70 Core cooling unit and retention ring can then be installed on the motherboard. The M4 screws will screw right into the mounting holes on the motherboard. Again tighten these in an X pattern to ensure the pressure is even resulting in a good mount on the CPU.