By Johan Nyman, on September 8, 2017

You may have seen our latest Builders Gallery, do you want to see how that custom PC was put together? Then you have come to the right place! In this blog Johan goes through how he built the PC.

Continue Reading

By Johan Nyman, on May 15, 2017

We were at the UK LAN-event Insomnia 61 together with Overclockers UK. We had one of our influencers there, BoMenzzz, and we teamed up with Bit-Techs inhouse modder Dave "davido_labido" Alcock to build a custom watercooled PC for BoMenzzz that was revealed at the event. In this blog Dave himself will show how he built this custom PC.

Continue Reading

By Johan Nyman, on December 21, 2016

In this last blog of the Project CURV3D series we go through how the hardware is installed in the case and of course photos of the final result!

Continue Reading

By Johan Nyman, on December 21, 2016

This is the fifth part of the Project CURV3D blog-series where we show you how it could look when you build a case from scratch.

Continue Reading

By Johan Nyman, on November 9, 2016

In the last blog in this series I showed how I made the backplate, how to paint aluminium and test fitting the hardware. Now it is time to make some custom-cables, sleeve them as well as building a custom SSD-holder.

Continue Reading

By Johan Nyman, on September 30, 2016

In the last How to Mod blog I went through how to paint the radiator on the H100i v2. I painted mine for a project with a Mirror’s Edge theme, do you want to see how it turned out?

Continue Reading