SKU CW-9060031-WW
Hydro Series™ H150i PRO RGB 360mm液冷CPU散热器
CORSAIR Hydro Series H150i PRO是一款一体式RGB液冷CPU散热器，采用360mm散热片，专为实现低噪音散热而打造，泵头配备RGB LED，设计大胆前卫。
与CORSAIR iCUE兼容
CORSAIR Hydro Series H150i PRO是一款一体式RGB液冷CPU散热器，采用360mm散热片，专为实现低噪音散热而打造，泵头配备RGB LED，设计大胆前卫。
与CORSAIR iCUE兼容
CORSAIR Hydro Series H150i PRO是一款一体式RGB液冷CPU散热器，采用360mm散热片，专为实现低噪音散热而打造，泵头配备RGB LED，设计大胆前卫。
泵头具有RGB LED灯，可以为您的设备打造灵动灯光效果。
三个低噪音120mm ML Series磁悬浮PWM风扇可实现更为卓越的空气流动性能，全速运转时，噪音仅25 dBA。
您可以利用CORSAIR iCUE软件对RGB灯光、每个风扇的转速和水泵运行速度进行调整，同时还可以对CPU温度和冷却剂的温度进行监控。
利用CORSAIR iCUE软件中的零转速配置文件，可以在低温条件下完全停止风扇运行，消除风扇噪音。
高级泵速控制选项可最大程度发展性能，或尽可以降低噪音。
模块化设计，无需工具即可安装支架，可在大多数主流CPU插槽上实现快速无忧的安装。
The new Intel® Socket 2011, used on the new X79 motherboards and the new 2nd generation Intel Core Sandy Bridge-E CPUs, has changed significantly from Socket 1366. As you can see below there are no longer the traditional holes through the PCB. There is now a metal bracket that has been tapped to accept M4 screws. Because of this the Corsair
Hydro Series H70, H80 and H100 CPU coolers all come with separate screws to mount on Socket 2011 boards.
Included with the H80 and H100 are four standoffs that have a shorter wider end. These are for socket 2011, the shorter end screws into the metal mounting plate on the motherboard.
Install all four of the standoffs as shown below.
After installing and tightening down all four standoffs, the CPU cooler is ready to be installed.
Next the thumb nuts are installed. Tighten these in an X pattern to ensure the pressure is even, resulting in a good mount on the CPU.
The H70 Core uses the same bracket for socket 1155, 1156, 1366, and 2011. Again socket 2011 uses larger M4 screws and does not need the backplate. Make sure all of the holes on the retention ring are towards the outside (as seen below). Then install the M4 screws through these holes.
The retention ring should then be put on the H70 Core. The H70 Core cooling unit and retention ring can then be installed on the motherboard. The M4 screws will screw right into the mounting holes on the motherboard. Again tighten these in an X pattern to ensure the pressure is even resulting in a good mount on the CPU.
